Warren Tooling Ltd
+44 (0) 1189 441435
Warren House 89 Reading Road
Woodley, Berks,
United Kingdom
RG5 3- 3AE
the website provides a range of cbn (pcbn) and pcd (diamond) tooling and explains the different grades that are available. defining grades for specific application areas in the automotive, aerospace, bearing and general engineering industries.
Products & Services
-
- Cbn
- Pcbn
- Pcd
- Hard Turning
- Grey Cast Iron
- Cubic Boron Nitride
- Sumiboron
- Amborite
- Bzn
-
- Silicon Aluminium
- Inconel 718
- Nitride De Bore
- Automotive Industry
- Gear Machining
- Best Grades
- Replaces Grinding
- Cost Effective Solutions
Web Result
- Warren Product 1
- PCD info PCD information Troubleshooting Tips Useful machining information Where NOT to Use PCD [Home] [Aboutus] [Products] [Contact Us] ...
- Where NOT to Use PCD
- PCD info Where NOT to Use PCD Steel and irons - Iron can be used as a solvent catalyst to change graphite to diamond under conditions of high pressure and temperature. Consequently the heat generated during the cutting of these materials with PCD causes the cutting edge to graphitise resulting in rapid wear. There are exceptional circumstances where PCD can be successfully used for machining irons...
- Warren Products Page
- Products CBN - Cubic Boron Nitride Warren Tooling offers a comprehensive selection of CBN grades. The different grades cover the complete range of CBN application areas. Including finish and rough machining of hardened steels, grey cast iron, chilled cast irons and hard facing alloys and some superalloy materials. The different grades vary in CBN concentration, grain size and binder composition so...
- Useful machining information
- PCD info Useful Machining Information for PCD Handle inserts with care - Tool life can be greatly reduced by mishandling inserts when setting up. For example contact with the probe on tool pre-setters can cause minute chips on the cutting edge. Reduce vibration and chatter - A rigid set up will ensure maximum too life can be achieved. Use the correct sized PCD segment - Depth of cuts should be lim...
- Warren Product 2
- PCD Grades PCD Grades WD30 A medium grain sized PCD material. An average grain size of 10 microns provides a combination good edge quality and wear resistance. A utility grade suitable for machining a wide range of non ferrous and non metallic workpiece materials. Can be used for both turning and milling of Aluminium alloys. WD50 A coarse grain sized PCD material. An average grain size of 25 micro...
Website Links:
Own this business?
Request to update the information