Products & Services

• • Dumont
  • Minute Man
  • Broach
  • Keyway
  • Push Type
  • Pull Type
  • 500series
  • 600 Series
  • Square
  • Hexagon
  • Round
  • Keyseater
  • Keyseating
  • Spline
  • Serration
  • Surface
  • D-hole
  • Double D-hole
  • Rectangular
  • Production
  • Metric
• • One-pass
  • Tin Coated
  • Keystock
  • Arbor Press
  • Shim
  • Special
  • Broaches
  • Broaching
  • Bushings
  • Bushing
  • One Pass
  • Tin Coated
  • Broaching Bar
  • Guides
  • Plug
  • Collet
  • Kits
  • Cutter
  • Tialn
  • Ticn
  • Futura

Web Result

Warning Information

The duMONT Company, LLC Made in the USA Warning Information Cutting tools may shatter or break, therefore eye protection should be worn wherever and whenever cutting tools are being used. Government Regulations require use of safety glasses and other appropriate safety equipment at all times in the vicinity of cutting tool use. Broaching Hints Length of Cut Set-Up and Alignment Workpiece Material ...

http://www.dumont.com/resource-center/warning-information/

E Style

The duMONT Company, LLC Made in the USA Metric Bushings by Broach Style duMONT Minute Man Keyway Broaches and Bushings have letter designations signifying the width of the Keyway Broach and the guide slot in the Bushing. The Bushing size and Style are determined by the bore diameter of the workpiece as well as the Style of Broach to be used. "A" Style Broaches are used with "A" Style Bushings, "B-...

http://www.dumont.com/bushings-shims-arbor-presses/metric-bushings-by-broach-style/e/

Broaching with Production...

The duMONT Company, LLC Made in the USA Broaching with Production Keyway Broaches Broaching with Production Style Keyway Broaches requires no Shims or Bushings. The back and shoulders of the Broach are ground to fit the diameter of the bore, supporting and guiding itself while cutting the keyway in one pass. All individual stock Broaches have recommended Minimum and Maximum Length of Cut guideline...

http://www.dumont.com/resource-center/standard-broaching-procedures-guide/broaching-with-production-keyway-broaches/

Length of Cut

The duMONT Company, LLC Made in the USA Length of Cut duMONT Minute Man Broaches are designed to be used in operations where a minimum of two teeth are engaged at all times. Tooth engagement is required to maintain a smooth cutting action promoting a clean finish. The chip generated during the cutting process must be contained within the gullet of the tooth to avoid binding of the tool. This could...

http://www.dumont.com/resource-center/broaching-hints/length-of-cut/

Standard Broaching Procedures...

The duMONT Company, LLC Made in the USA Standard Broaching Procedures Guide duMONT Minute Man Broaches are designed for fast, accurate, and convenient broaching with arbor or hydraulic presses. A study of the Broaching Procedures presented in this section will familiarize the operator with proper broaching procedures and troubleshooting practices. Following proper broaching fundamentals, paying at...

http://www.dumont.com/resource-center/standard-broaching-procedures-guide/

Website Links: