iel identequip marking machines and systems for the steel and metals industry including slab, bloom, billet, coil, section, plate and pipe markers.

Products & Services

• • Identequip
  • Iel
  • Slab Marking
  • Billet Marking
  • Bloom Marking
• • Coil Marking
  • Section Marking
  • Plate Marking
  • Tube Marking

Web Result

Automatic marking of hot rolled beams and profiles

SECTION MARKING IEL supplied the world s first metal spray, beam marking machines in 1993. The conventional way of marking beams has been to stamp them by hand or automatically by machine. Both these methods are expensive and suffer from poor legibility. Dot matrix paint marking has been used but with limited success where the temperature of the section is high. Marking should however be done as e...

http://www.identequip.com/Section%20marking.htm

Automatic spray marking of hot rolled coils

METAL SPRAY. IEL supplied the world s first metal spray marking machines in 1995. The conventional way of marking hot coils is by using dot matrix paint spray. See Principle of marking if you are not familiar with this term. Metal spray marking machines do however have certain advantages, the main ones being: Very high quality marks. Very high reliability and availability of the machine. Minimum a...

http://www.identequip.com/Coil%20marking.htm

Automatic marking of hot billets and blooms

Billets and blooms can be either spray marked or stamped. However, as the trend is towards spray marking, the following notes relate to this method but also dot matrix stamping is available should this be preferred. IEL designed and supplied the world s first metal spray billet marker in 1989/90. See Principle of marking if you are not familiar with this term. We can supply units to mark character...

http://www.identequip.com/Billet%20and%20Bloom%20marking.htm

Automatic marking of cast and rolled slabs.

IEL installed the world's first two Metal Spray slab markers into Cockerill Sambre in 1983. Since then we have supplied some 20 slab markers around the world. See Principle of marking if you are not familiar with these terms. Slabs are normally marked on the side or on the end, the location usually being dictated by the way the slabs are transported and stacked in the slab yard. Unusually, there a...

http://www.identequip.com/Slab%20marking.htm

Principle of IEL Identequip marking systems

METAL SPRAY The principle of metal spray marking as supplied by IEL is based upon melting and then blowing aluminium or aluminium bronze particles through a stencil onto the hot product. The stencil is in the form of a disk or a rimmed wheel with the characters concentrically cut out of the disk or the rim using laser. The disk is then rotated much like on a daisy-wheel printer for character selec...

http://www.identequip.com/Principle%20of%20marking.htm

Website Links: