Products & Services

• • Switchgear And Switchboard Apparatus

Web Result

17-About OmniTurn

OmniTurn CNC Lathes & Attachments. Made in Oregon! The World's Most Cost-Effective Turning Machines OmniTurn Factory Floor About OmniTurn OmniTurn is the registered trade name for the CNC lathe products manufactured by NC Electronics, Inc.(NCE). NCE was established in Southern California in 1976 for the purpose of retrofitting older large NC milling machinery to state-of-the-art CNC technology...

http://www.omniturn.com/bin/about.htm

10-OmniTurn ZipLoader

OmniTurn Ziploader Made in Oregon! Fast Simple Compact Smart! It's an automatic bar loader! Loads bar for machining and cutoff; pushes more bar for next part. At end of bar, ZipLoader ejects remnant and loads new bar. Tray holds 40 half inch bars for hours of un-attended operation. It's an automatic shaft loader! Loads part for machining locks it in collet. Then it ejects finished part, gets next ...

http://www.omniturn.com/bin/OmniTurn%20Ziploader.htm

15-Vertical Cut-off

OmniTurn New Generation CNC Control Fast... Precise... Affordable... Vertical Cut-off (VCO) Vertical Cut-off provides quick part-off without using space on the table. Servo-control allows simultaneous part-off to start while turning; can also be used for grooving. Frees up space on tooling plate Servo controlled Programmable for feed and depth Can be used for grooving Cut groove while turning or f...

http://www.omniturn.com/bin/vco_02css.html

OmniTurn Purchase CNC Lathes Factory Direct!

Omni Turn CNC Lathes & Attachments. Made in Oregon! The World's Most Cost-Effective Turning Machines 1-Series II/III (GT-75) 2-Series I (GT-Jr) 3-Attachments 4-16C Retrofits 5-CNC Controls 6-Custom XZ Slides 7-Download Software / PDF's 8-Repair Parts 9-Rebuilding your OmniTurn 10-OmniTurn ZipLoader 11-TripleAir Bar Feeds 12-Used OmniTurns 13-Toolbar Inc. 14-3-Phase Live-Tool Motor 15-Vertical ...

http://www.omniturn.com/index.htm

OmniTurn CNC - C-Axis Plane Switching

OmniTurn New Generation CNC Control Fast... Precise... Affordable... XC mode: the live tool works on the face of the part. The XC mode is started with the command (~PLXC). Before entering this command the live tool must be located on the negative X side of the part, with its spindle centerline parallel to the lathe s Z axis. On entry, the Y position is 0, and the X position is the distance from th...

http://www.omniturn.com/bin/plane_switching_02.html

Website Links: